Saturday, December 2, 2017

Grumman F9F-2 vs. F9F-5 Wing Root Comparison

On my 2009 post comparing the F9F-2 with the -5 (http://tailspintopics.blogspot.com/2009/10/grumman-panther.html), "davedd" commented that there was a difference between the interface of the fuselage break and the inboard trailing edge of the flap. I hadn't noticed that before, but he is correct.
The F9F-2 example is a crop from the Luc Colin walkaround photo collection in Prime Portal HERE. The F9F-5 example is a crop from the Howard Mason walkaround photo collection in Prime Portal HERE.

The reason is that the -5 had a thinner outboard wing (10%) than the -2's (12%) in order to delay the drag rise at transonic speed, an aerodynamic benefit demonstrated in flight test of Air Force and Navy research airplanes in the late 1940s.
Note that the thickness ratio can be reduced by either decreasing the thickness of the wing or increasing its chord.

Since it was desirable to retain the depth of the wing at the wing fold, the location of the wing-folding hardware and the main landing gear, and still reduce the thickness ratio there, the wing and fairing chords were increased on both sides of the wing fold. The change to the leading edge is obvious but it turns out the trailing edge was moved aft as well.
 Hence the difference in the interface between the fuselage break (which remained at the same fuselage station) and the inboard trailing edge of the flap.

Note that the end of the wing-to-fuselage fairing was relocated aft as well to decrease its thickness ratio as well (on the F9F-8 Cougar, it was moved all the way aft to the end of the fuselage).

1 comment:

  1. Great! Thank you. The drawing make it very clear. Regards

    ReplyDelete